Hi,i have this message come up in the new rig manager,it was fine but after newest update the message reads some items in profiler are damaged,turn off profiler wait 10 seconds and choose browse mode while holding the rig button for 30 seconds.do i turn it back on and then hold the rig button or wait till it shuts down and hold rig button? dumb question i guess but it does not say to turn it back on while doing this.
Message from rig manager some profiles are damaged???
- pikman
- Thread is marked as Resolved.
-
-
Switch the Profiler off. Then press and hold the RIG button and then set the chickenhead from the OFF position to the Browse position.
As soon as you see "Initialising current rig" in the display you can take the finger off the RIG button. -
After waiting at least 10 seconds after shut-down, hold the Rig button down and select Browse mode (which will turn it on).
A message/s should appear stating that the Kemper is scanning Rigs / checking for damaged Rigs / rebuilding Rig database or something to that effect. If you see this sort of message, it's doing what you want it to.
Good luck, pikman.
EDIT:
Damn you, Hans-Jörg; you're too-quick for me, mate. -
Thank you to both of you,i will try what you both suggested.Fingers crossed.
-
It is doing exactly as you both said.It is checking rigs at the moment.It just finished should i try Rig Manager again?
-
i cannot see any reason why you should not.
-
All good now,many thanks to you both.RM works now also.When all else fails enter the forum