I would like to use two morphing pedals (Boss EV 30) with the remote. One for reverb/delay amount and one for gain control . They are in inputs 3&4. Adjusted in the system settings (Type 1 / Morphing). The problem is: whatever I adjust for one of the pedals, the other follows. I cannot tweak them separately . Any advices ?? Thank you !
Using Two Morphing Pedals
- Armadillo
- Thread is marked as Resolved.
-
-
While you can use several pedals to control morphing you cannot assign different morphing destinations to each pedal.
-
Thank you !....hmmm....so I just can use ONE pedal for morphing at a time. And maybe another one for volume, and one more for wah. But for what reason is it possible, to connect up to 6 (six !!) pedals to the system if not for different parameters ?
-
you can use pedals for volume,pitch, wah, morph and monitor volume. You can also use the pedal inputs to connect footswitches to switch between rigs, activate stomps etc.
-
ok understood ! Thanks very much !!
-
Instead of morphing the parameter Gain, I suggest you configure your second pedal as a Volume Pedal and place it pre amplifier (either Pre Stomps or Post Stomps), which is the default in our Factory Rigs. That way it effectively controls the amplifier gain.
Volume Pedal Location is a Rig specific parameter, but Volume Pedal settings can be locked.
-
Yeah....thats a good advice..thank you !!