Where to place a Robotalk?

Quote from Finally

I want to add a really great envelope filter like a Robotalk to my Kemper and have a couple of questions. Ideally I'd have it connected to the effects loop of the KPA and assign it per rig. I don't run any other pedals, so I'd have to cable and power the pedal otherwise.

It's for clean and slightly hairy tones mostly.

1) Is this likely to sound as good as running into the Robotalk straight into the KPA?

If you put the FX Loop into Slot A, it will sound the same as the front end of the KPA (if you have Clean Sense and Distortion Sense both set to "0")

2) If not and there's noticeable latency how obvious is it likely to be? I realise it's subjective, but for you.

The FX Loop does not add latency.

Display More

Youre welcome

If it is the only Stomp used, it could be in A. B. C. or D.

I mentioned using it in A, because placing something else in front of it could change the sound, compared to running it straight into the KPA.