I received an error to the effect of "Cannot Communicate With DSP Board"
This happened while in Browser mode.
I'm very concerned, and would like as much info as possible on this error please and any diagnostic tests I can run. This is time critical so your help will be most welcome. Many thanks.
Note: I have recently upgraded from OS v3 to the latest (non beta) version of OS 5.xx
Thanks
UPDATE [10 minutes later]:
I was then able to change a few parameters then dials started to be inoperative (turning had no effect, buttons no good) I changed out of Browse mode to Perform mode, I was able to change EQ but not rig.. then all functions froze and no dial or button worked. After 5 minutes of frozen Kemper I turned it off. Now I'm unsure what to do.
Update 2:
Turned unit back on and it told me to update time and enter my name (which was present and correct).
How do I diagnose this? Do I re-install OS? Run a diagnostic? Please help.
Profiles are visible but I'm unsure what is best to do. I guess this DSP Error happens for a reason?