Looper position - (non remote) eureka fcb1010

  • Hey Guys,


    I have started using the looper function with my eureka fcb1010 but I cant move the looper to the output. It makes it much less usable only located at the input.


    I have checked under the setting where the remote is and the pre post section for the looper is greyed out.


    Any advice? Help?


    Thanks in advance!

  • You're welcome. I was quite frustrated by the looper and getting annoyed that I wasn't able to use it how I wanted, just because I chose not to buy the remote and then it became clear.....

  • Hi,
    you mean, placing the looper to "post" position in order to change the rig and having the loop with the original looped tone sound?


    for this you need to go at System Menu, at the last pages you will see grayed the Kpa Remote options, there at the right upper corner of the lcd you have
    Looper "pre" than you switch the knob to "post" and even grayed you can change it...


    hope you can have fun with it!
    best regards
    Claudio