Hi,
I just received my Kemper. I will be using it live through a 4/12 Marshall cab. Is there a standby button as with traditional amps so I can have it ready to go when I go on?
So far, I love this amp. Thanks all, nice to be here.
Using Profiler Amp for Live but no standby?
- TomAllen
- Thread is marked as Resolved.
-
You don’t need a standby button for the amp to be ready to go when you need it. If you want to have it powered up, but not be able to make any sound, just turn the chicken head knob to the tuner position. Then, when you are ready to play, turn it to browse or performance mode.
Note-the above paragraph assumes that you have your tuner set to mute the output of the KPA when the tuner is active.
-
You’re welcome!
-
I just had mine sitting ready on the first performance but volume heel down which puts it into muted tuner mode. When we started it was like pressing the gas pedal!
-
So far, I love this amp. Thanks all, nice to be here.
Welcome, Tom. It's a wicked piece of gear for sure!
-
Yes,no valves to warm up or deteriorate so just leave it on before you start or in between sets and mute with the tuner..
...and welcome!
-
Or, you can just turn down the guitar volume knob.
-
True!
Leaving on tuner reminds me to tune up
