Spring Reverb spillover between rigs ?

  • If I understand it right, the only way to get reverb spillover between rigs is that the Spring reverb must be in the Reverb Block on the
    Kemper. Will it be possible to get spring reverb in the Reverb block on the Kemper when the reverb update is finish?

    Kemper Stage, KPA head, Remote, JH Audio Lola IEM, Shure PSM 900 wireless System, L-Acoustics 108P active FRFR monitor.

  • A guess based on logic:


    If placed before the amp block, spillover won't be possible because when the Profile itself is changed, audio output (from the amp block) is temporarily suspended.


    If positioned after said block, the delay or 'verb's output should remain uninterrupted 'cause Profile switching would have no bearing on it.

  • Only the two last blocks on the Kemper, the Reverb and Delay block work with spillover effect from rig to rig.
    If you copy a delay from the delay block and paste it into X or Mod block the delay will not have spillover effect from rig to another rig,
    even if you have the same delay in X or Mod block on the rig you change to.

    Kemper Stage, KPA head, Remote, JH Audio Lola IEM, Shure PSM 900 wireless System, L-Acoustics 108P active FRFR monitor.

  • Only the two last blocks on the Kemper, the Reverb and Delay block work with spillover effect from rig to rig.
    If you copy a delay from the delay block and paste it into X or Mod block the delay will not have spillover effect from rig to another rig,
    even if you have the same delay in X or Mod block on the rig you change to.

    Interesting.


    I wonder if this'll change with the new "put it anywhere you like" status the 'verbs will have in future, and if, after the "effects overhaul", the delays' spillover will be taken care of too.

  • Spillover as well as wet output sources work in the two modules DLY and REV exclusively. So, if you place Spring Reverb in the DLY module you can enjoy spillover already now. It's not planned to enable spillover in all modules.

  • Burkhard, will the Spring rev be incorerated as a reverb type like hall, plate etc in the rev block to get spillover effect?
    I think most players will only use one reverb effect pr rig ,
    so that would be great if that can be incorpareted in the new upcoming reverb update.

    Kemper Stage, KPA head, Remote, JH Audio Lola IEM, Shure PSM 900 wireless System, L-Acoustics 108P active FRFR monitor.