I finally got around to upgrading my Behringer FCB1010 MIDI controller so that it can send and receive MIDI to and from the Kemper as well as be powered over a single Ethernet cable. Below are the schematics that I came up with and some pictures. I apologize for not having any pictures of inside the FCB1010 as I had already re-assembled it before taking pictures. However, there are other threads that detail that.
I hope this helps anyone else who is having trouble making sense of some of the other schematics on the web. It's not that hard of a project and it works incredibly well. Now, I don't have three cables on the floor, I only have one. Word of advice. After drilling any holes in the FCB for the RJ45 jack MAKE SURE TO VACUUM OUT ALL METAL SHAVINGS. When I first put everything together, it would randomly power off. After lots of head scratching, I cleaned out the floor board really good and found a metal shaving touching the eprom which was causing it to lose power.
Here are links to the box and the connector.
https://www.amazon.com/gp/prod…age_o05_s00?ie=UTF8&psc=1
