is there a way to control volume in the cabinet block?

  • I typically run 5 rigs live that run from clean to distorted. I use the rig volume control to balance the volumes. The trouble is that they balance differently depending on whether I'm going through the PA or through my cabinet. Since I run the cabinet block for the PA channel and not for the cabinet channel, I figured that an easy solution would be to balance for the output that goes to the cabinet (cabinet block turned off) and then adjust the level of the cabinet block per rig for the PA channel. The only problem is that I don't see a volume parameter for the cabinet block - just the single page of high shift, low shift, character, pure cabinet controls. Does anyone else have the same problem? Any clever suggestions for how to adjust relative volumes for the two channel, but per rig, where the only difference between the two channel is that one has the cabinet block enabled and other doesn't? Thanks,
    Eric