What output for cab?

    Hi guys. Do I use the Speaker Output when connecting my Kemper to a guitar cabinet and then turn the power amp on?


    If it’s an active speaker like the Line 6 Power Cab would it be Monitor Out?


    It’s also a 1x12, do I need to do anything in the settings?


    Thanks.


    It’s been a while!

    Edited 3 times, last by PhilUK84 ().

    Quote from Burkhard

    yes, the outputs are correct, for guitar cabinet activate "Monitor Cab. Off" and for full-range cabinets don't.


    These subjects are covered in the manuals.


    Thanks for your reply. I know that, and I used to to use a cab at times, but I also blew my Kemper up once so I really don’t trust myself :D


    And what about the output volume settings? Do I need to change anything to master mono or anything?

    The only thing to be careful of really is connecting to an active cab.


    For passive, totally, use the speaker out like an ordinary amp. You should not need to change anything except the master volume ( I would also unlink volumes as well).


    For active use xlr outputs ( monitor I think).