Finally got my Kemper sounding good and getting my rigs set up. I'm using the Kemper remote and have the rise and fall times set to zero because I need instant change.
I would like the bottom half to be a crunch "dry" setting. I have my Morphed "B" side with more gain and more volume...no problem.
But when I Morph to the upper half of the same channel, I'm finding that I can't add Delay or Chorus, or anything for that Morphed side only, it affects both A and B sides.
I want to have the dry channel to be on the A side, and the B side (Morphed) to have more gain and volume PLUS a delay, and Chorus for the B side. Then go back to A and have the dry signal again.
So far, everything I try put the effects on both side. Can this be done?
Cheers and thanks.