Remote lights on switches...

GTARPLR · Oct 15th 2018

I noticed that when I watch any tutorials from Kemper that have the remote, all the lights on the buttons 1-8 are off EXCEPT for the one that's actually activated.

On mine, I see all the lights 1-8 are partially on, then the green light glows brighter for the one that's actually on. It's only a slightly brighter amount. I would like to have the lights 1-8 to be all off except for the one that's supposed to be on, or the Morphed channel.

I've gone into the setting of the remove on the Kemper for the remote, but I'm unable to achieve what I'm looking for.

Any ideas?

Burkhard · Oct 16th 2018

Difference between Browser Mode and Performance Mode.

Wheresthedug · Oct 16th 2018

Quote from Burkhard

Difference between Browser Mode and Performance Mode.

i have never looked into this. Are you saying that all should be OFF in Browser mode but all slots in use in a performance have a faint glow to show they in use but not selected? That makes a lot of sense.

Burkhard · Oct 17th 2018

In Performance Mode the enabled Slots of the Performance currently loaded are indicated by dimmed lower LEDs. The Slot currently loaded is indicated by a bright lower LED. If any lower LED is off, then the corresponding Slot is disabled as it cannot be loaded remotely.

Browser Mode only indicates the Rig currently loaded by a bright lower LED.

Wheresthedug · Oct 17th 2018

That makes a lot of sense and is another example of the KPA /Remote integrating seamlessly in the real word. thanks Burkhard

Share