I have a toaster the version powerhead .
In general have two problems.
1. My frfr speaker is connected to direct out/monitor outputs mapped to master left/right. When I turn on the device I hear the popping sounds from the speaker until it’s fully booted then it stops.
2. The same configuration but power amp turned off in output settings, when booted, when I crank up the volume level of my cabinet to 40% or more, I hear popping sounds very regular around 1hz. Even without playing anything. Problem disappears when I turn on power amplifier in the output settings
Any ideas ?
my connections with stereo frfr speaker
https://www.dropbox.com/s/7f4x…vjiu/connections.JPG?dl=0
kemper startup and popping sound demonstration
https://www.dropbox.com/s/vmwg…during-operation.MOV?dl=0
turning power amp on in settings may solve the problem, but not during kemper boot time
https://www.dropbox.com/s/m21m…f-solves-popping.MOV?dl=0
When i connect to main outs, there's no problem as far as i tested it.
Also when i connect only one signal (wheter monitor or directout) then problem also is not here.
so main issue is when having both outs (monitor & directout) connected to frfr speaker.
Thank you