Updating analog board firmware

  • Hi....


    can anyone explain why it is happening?


    updating analogboard firmware .......


    in the last 10 months I happened twice.


    the first time 10 months ago

    I started kemperamp, finished the tone test, everything was ok.

    I started to gig and I noticed that my output volume was too low ... I checked all the cables and equipment all was ok but the volume in the monitor and the FOH was too low ...

    I turn off kemper and tried to start it again and then ...

    UPDATING ANALOGBOARD FIRMWARE


    Two days ago I installed a new beta version of the software and I thought it might be because of that ....


    I plugged the usb stick on which I had the latest official software version, press page button, left and right together and started reboot ..

    After three trials and half an hour delay , kemper did a reboot ...


    The second time was Friday, November 16th


    I finished the tone test and everything was ok ... before the end of the test I noticed a big buzz .. I thought it was a voltage, ....

    turn off the kemper, turn on the power supply to the second socket and then


    updating analogboard firmware...


    Since the first time I did not install any new software version. I did not connect to rig exchange ....


    Usb stick IN, both page button, kemper on .... I tried reboot but nothing has happened ....

    After half an hour, I and several attempts turned off all the pedals and cables that were connected to the kemper ... and started the reboot and after two minutes kemper did reboot


    Does anyone know why this is happening?

    How to avoid this because I slowly lose confidence in the kemper?

    why a few reboot attempts are needed?


    Equipment


    kemper

    kemper remote

    mission E. EP1-KP

    volume pedal

    red sound RS LG12