KPA Remote question

OneEng1 · Jan 24th 2019

Hi All,

I have a quick question on the KPA remote.

If you have the KPA hooked up to your Kemper Remote, I noticed that there are 2 LED's above EACH slot button (1-5). One LED is closer to the button, and the 2nd LED is above the first.

All 5 LED's are lit dimly, and one of them (the selected one) is lit brightly.

If you hit the currently selected button again, the bottom LED becomes lit dimly, and the top LED becomes lit brightly.

Is there some feature associated with this that I am not aware of?

Thanks in advance for your attention.

mrs-zambesi · Jan 24th 2019

It reflects the morph status. You can use the buttons to switch between "normal" and morphed, Has only an effect if you have some morphing dialled in, obviously.

OneEng1 · Jan 24th 2019

Ahhh. I see.

Thank you very much! I looked around at the documentation, and on-line videos but never found this little tidbit of information

Atlantic · Jan 24th 2019

Yes, you can morph each one of the 5 rigs to effectively have 10 different sounds just using the 5 slots. Which combined with the stomps and effects section gives me a total of... Too many.

Troy_e · Jan 24th 2019

How I use the morph is on the lower unmorphed state. I have my profile and add reverb, delay etc. mix at zero, then in morph state I up the mix in and add gain and chanell volume.

Share