I'm using the spring loaded mission pedal for the wah on the Kemper. I have set the wah to dis-engage at heel position. The problem I have is the wah cuts off instantly when I'm at heel, but what I'd like is to cut off after, say, 1 second. Is that feasible with the kemper wah parameters?
mission pedal spring loaded and wah
- lk_bill
- Thread is marked as Resolved.
-
-
Bypass is engaged instantly, based on pedal position. You may have to hold the pedal with your foot a second longer.
-
My impression is that Wah is a little longer "on" when using Bypass@Stop.
-
Bypass is engaged instantly, based on pedal position. You may have to hold the pedal with your foot a second longer.
My issue with this is that I tend to hit the toe position a lot while playing with the wah.
I'll try KemperManiac' suggestion to use the bypass@stop instead.
-
I like to use bypass@stop, too.
-
Tested last night and realised I had it on bypass@stop too. Tried the bypass@toe, the behaviour is not dramatically different.
I'll try with a non spring loaded expression pedal to see the difference.
-
I use bypass stop and it does take a few milliseconds to stop ( which I like)...