Jump in Volume when activating LOOP

absrec · Apr 2nd 2019

Has anyone else experienced a jump in volume just for maybe 1/2 second when engaging the LOOP in the stomps section? I have a booster pedal hooked up according to the instructions in the manual. I'm using [LOOP DISTORTION] since it's a technically a gain pedal. It will return to what seems like the correct volume after the initial spike in output. It's not going to work as is because I may want to engage the LOOP in the middle of a song.

Sorry if this has been covered already. My searches only turned up info about the phrase looper functions in the KPA.

Thanks,

-Aaron

Kemper Support #1 · Apr 2nd 2019

try setting the output source for the direct out to "off" while the FX loop is not activated.

absrec · Apr 4th 2019

Quote from hjscheffler

try setting the output source for the direct out to "off" while the FX loop is not activated.

That was it! Makes perfect sense.

warlus1 · Apr 5th 2019

Quote from hjscheffler

try setting the output source for the direct out to "off" while the FX loop is not activated.

where?
'cause i ve got a issue with "stereo or mono loop fx" (strymon timeline) : when i change a patch ( and sometime even with a muted guitar via a footcontroler) i can heard a lot of my external delay fx (5.7 release) or a jump volume too (like above)

thanks.

Burkhard · Apr 5th 2019

Output Source of DIRECT OUTPUT in Output Section.

Share