Can I use both sets of outputs simultaneously? One set to frfr, the other to my mixer?
Thanks,
Mark
Main out
- progguitar
- Thread is marked as Resolved.
-
Yes, just set your output settings for mono.
And welcome to the forum!
-
The main XLR and TS outputs are simply different hardware outputs of the same signal; the Kemper software doesn't differentiate between them. You can use either or both sets at the same time, however:
In your situation, you could use the Monitor Out for your FRFR cab and either the main XLR or TS outs to feed the mixer. This way you'd have extra control over levels - you could, for instance, optimise the Monitor Out signal being sent to your cab without affecting the Main-out signal, and the Main-out level going to the mixer without affecting the Monitor-out signal.
Welcome to the forum, Dan.
-
In your situation, you'll have to use the Monitor Out (Cab off) for your FRFR cab and either the main XLR or TS outs (Cab on, as stereo or mono if you desire - you can set that in your output settings) to feed the mixer.
I don't think he wants to turn off the Cab for an FRFR speaker. I'm fairly certain that using the two Main outputs will work as expected when set to mono ...
-
D'Oh! Talk about a brain fart. Thank you, Larry!
Post edited.
