I've already contacted support via email.
No matter which guitar I plug into the front, which amp/speaker setup I use to monitor, or which 3rd party profile I load, there's something 'off' with what I'm hearing out of the unit. My best guess at this point is either the input or output stages.
- Have owned the unit quite a while but only started seriously using it these past few months. This issue has always been there to some degree and I should have addressed it years ago.
- I've exhausted every troubleshooting option from both the input and output sides of the unit.
- I've managed to mask the problem to certain degrees using lots of EQ and compression - only somewhat works with certain rigs. I've even modified my picking (less attack) to try and lessen the problem.
Plugged in this morning and realized I was having to use way too much processing and my fundamental tone was suffering. I did a factory re-boot and then tried a number of rigs from various third parties and with zero processing - YIKES!
Brittle, glassy, transient spikes if I dig in hard, and overly sterile sounding when completely dry using a clean amp. You older folks remember how the guitar would sound if you plugged it directly into a home stereo? There's a little bit of 'that' going on.
Will keep this thread alive and updated as things progress.