Two connection questions

GuyJames · Apr 19th 2019

Forgive me if these have been answered but I couldn’t find any clear answers online or in the manual.

Should I be using Low or High Z XLR cables to connect the Kemper to an interface or mixer? Sadly enough I didn’t know there was a difference but noticed high and low z written on two different xlr cables.
When I do connect the Kemper to a input on my interface, should it be set to line or mic level?

Thank you ??

-Guy

GuyJames · Apr 21st 2019

DonPetersen you’re the expert, can you enlighten me?

nakedzen · Apr 21st 2019

Low z cables are for very long cable runs (1000+ feet) to avoid high end loss from the microphone. There's no difference in the home studio environment if you keep cable runs under 20 feet.

Kemper Support #1 · Apr 21st 2019

the PROFILER sends line level signals at its outputs. You can use a standard XLR cable or a TS cable to connect the PROFILER to your interface.

GuyJames · Apr 21st 2019

Quote from Kemper Support #1

the PROFILER sends line level signals at its outputs. You can use a standard XLR cable or a TS cable to connect the PROFILER to your interface.

So the Kemper sending line level means the interface input should be set to line as well correct? Thanks for responding. ??

Kemper Support #1 · Apr 21st 2019

Quote from GuyJames

So the Kemper sending line level means the interface input should be set to line as well correct? Thanks for responding. ??

yes

Share