Hello all, so I installed the latest operating system via a USB stick.
After that, there was some distortion on my Kemper screen that wasn't there before, line of pixels is basically missing. So where it says 'Bass, Middle,' etc the letters are split in two along a horizontal line.
On a more minor note when I turn the 'type,' knob for reverb and delay, I can go into the stomp section for distortion, modulation etc . Wasn't able to do this before and its a bit annoying. Screen is obviously the main concern though.
If anyone could advise, that would be appreciated.
Screen distorted after installing latest firmware.
- Terence T
- Thread is marked as Resolved.
-
-
The screen looks like it have dead whole holizontal line of pixels.This is rather HW issue (poor contact with LCD) then FW issue (contact support).
DLY and REV modules are now like any other FX modules. You can place reverb and delay in any of the fx modules and all avaliable FX types in REV and DLY modules.
-
Ok, so what's the solution? Its only 13 months old, sitting in the studio all that time.
-