Reamping without SPDIF with Focusrite Clarett 2Pre and Cubase Pro

  • Where does the reamping process break?


    I assume that you have the DI signal recorded all good. (Not that it matters but I think you can use the front input for the guitar when recording DI, don't need to use the alt input on the back.)


    I am not sure about your interface and DAW config. I believe that your Kemper input config for reamp is correct. When you hit play in the DAW, can you see the input LED blink on the Kemper?


    If yes, can you hear the reamped signal through headphones?

  • I assume that you have the DI signal recorded all good. (Not that it matters but I think you can use the front input for the guitar when recording DI, don't need to use the alt input on the back.)

    Yes, i can record DI with Alternative Input (also it's work with Front Input). I connected now in Front Input



    When you hit play in the DAW, can you see the input LED blink on the Kemper?

    No, wrong config but i can't find where i do mistake



    If yes, can you hear the reamped signal through headphones?

    I don't have headphones

  • I hope someone who uses the same interface will chime in.


    Looked through your pictures again, I don't see anything wrong. If you switch that 3rd channel from output 3 to 1 or 2 and play channel 3, you can hear the DI signal in your monitors, right?