How can I get the Direct Out to send everything "except" time based fx? Which setting in the Output section do I set it to?
Thanks!
Direct out = no time based fx only?
- ewikman
- Thread is marked as Resolved.
-
If you only put Time Based Effects in the X, MOD, DELAY, or REVERB Slots, you can use "Stack".
This signal is tapped directly behind the stack section and does not include any post amp effects.
Note: The Output Source setting for DIRECT OUTPUT is only active when not in PROFILER Mode, no analog Effects Loop (e. g. Loop Stereo) is active, and “Monitor Stereo” isn’t activated.
-
If you only put Time Based Effects in the X, MOD, DELAY, or REVERB Slots, you can use "Stack".
This signal is tapped directly behind the stack section and does not include any post amp effects.
Note: The Output Source setting for DIRECT OUTPUT is only active when not in PROFILER Mode, no analog Effects Loop (e. g. Loop Stereo) is active, and “Monitor Stereo” isn’t activated.
Ok thanks very much!
