Hey guys just got a powered kemper and getting a Headrush frfr. I was wondering what output I use ( main out put?) and if someone could tell me what cable I need? sorry complete noob to it all. Thank you
Which out put to use and what cable for FRFR? Headrush
- Leonheart422
- Thread is marked as Resolved.
-
-
-
I use the Monitor out for my powered FRFR, and I use the Main Output(s) for FOH and recording.
-
It's a pity that the KPA doesn't have balanced monitor-outputs, but I use the unbalanced monitor-out (1/4" jack) for monitoring (+direct-out for monitoring in stereo). Main-outputs are used for mixing/recording. That way you can adjust your monitoring-volume separate from the signal you send to FOH/recording.
-
Thank you guys!
-
Leonheart, Congrats on the Kemper and Headrush.
I also have the same setup, but occasionally use a Thiele cab loaded w/ an EVM 12L.
The only thing I change on the profiler when using the Headrush cab is to lower the Monitor Output EQ Bass setting to a -0.5. (See Output Section Page 3 of 7)
It took just enough bass out for my ears. Your mileage may vary.