How to assign two differents reverbs (a short and a long) on the same profiler remote slot ?

    Dear all,


    I am trying to assign a short and a long reverb on the same remote slot. Is it possible to switch from one to the other ? I didn't find any tuto on youtube...


    Thanx for your help,

    Jerome

    You can have two reverbs located in the stomps and effects, and assign them both to the same switch. Set them so that one is on and the other is off. The switch will then toggle between them.


    And welcome to the forum!

    Go for it now. The future is promised to no one. - Wayne Dyer

    Like 3

    The other option is just to have one Reverb (assuming one Reverb type can do both sound - say Natural Reverb) andmorph the paramaters to create two different sounds. Which was is best depends on how you intend to use other things. If you are short of FX slots then Morphing frees a slot. If you want to use morphing for something else then two separate slots for reverb leaves morphing free. One of the beauties of the Kemper is that there are often several ways to achieve similar results so it can cater for different users individual needs and workflow.