Profiling a Profile

    I like to use analogue drive pedals in front of my Kemper. Since acquiring a second unit the thought occurs that I could make profiles from my 1st with the pedals on to create a new profile. I seem to remember a thread where someone profiled profiles as an experiment, backwards and forwards between two units until the sound fell apart, but I can’t find that thread. Anyone out there actually doing this and how does it sound?

    I tried to do this once before without a second Kemper. I did it by recording the "profiling noises" and reamping the noise through the Kemper. Then play back the reamped noise through the Kemper while in profile mode. I've picked up the experiment this week again. Might post some results this weekend..


    The old thread is over here:

    My Kemper profiled itself!