Switching Between Rigs in Performance Mode / Stomp Tone Settings Change ???

  • Updated...

    Let me try to explain this.


    I bank up or down to my desired Performance.

    Performance loads with Slot 3 rig selected.

    Stomp (Mouse) is active in slot/rig and Tone setting is at 4.3

    Slot 2 is selected.

    Back to slot 3 and Stomp Tone setting changes to 8.7


    Stomp Tone setting is only correct when performance is first loaded.

    Once I change between rigs/slots in the same performance Stomp Tone settings change in every rig and stay that way until I bank up or down.


    Does this make sense?

    Can anyone help?

    Edited 3 times, last by Matto ().

  • Did you check your input settings? Be aware of the fact that these settings are independent in browser and performance mode. You should also lock the input section because otherwise the input settings from the used rig will be loaded.

    I could have farted and it would have sounded good! (Brian Johnson)

  • Are the rigs in the slot morphed? Then the KP recognises the hit on the slot button as a second hit.

    I observed it when I found out that the tuner can be switched off by stepping on the slot button. If you step on the button which was acive when you switch on the tuner, the step on the slot button is recognized as the second hit an morph is activ.

  • Not morphing.

    Seems like stomp settings are changing arbitrarily.

    In Performance mode the tone settings on my Stomp C (Mouse) change when I switch from one slot/rig to the next.

    If I bank up to another performance the stomp tone setting is correct.

    If I switch to slot 3, the tone setting changes from 4.3 to 8.7

    Slot 2 changes from 4.1 to 8.2

    Tone Settings for Stomp C should always be 4.1 in slot 2 and 4.3 in slot 3 in both performances.

    I don't know why they change when I choose a different slot/rig.

    What do you guys think?

    Edited 2 times, last by Matto ().