Hello
I am new to kemper... and my english is not very good)
there is many ways to do that, but in short try to do folow:
1) connect cables from kemper to your audio interface as shown on picture
2) set Output Sources (press right top corner button , then navigate to page OUTPUTS, pressing page buttons) on page MAIN OUTPUTS -> Master Stereo (default value)
(Git Analog is default and only available for the DIRECT OUTPUT)
3) map inputs1/2 in DAW
I really wish the analog main outs had all of the same output settings as the spdif outs.
When using spdif it’s easy to just select Gtr/master mono to record di and amp’d sounds.
That option is missing from the analog outputs.
I’d prefer not to have to repatch or use other additional outs to accomplish this and I also don’t want to use spdif outs. When I was using spdif it was so easy to just select the Gtr/Amp split option, track bass and then change the setting back and track guitars.
Anyone know if there’s a hardware issue that won’t allow this or is it a software decision?
