Hi,
Sorry for the post, i'm not so sure if i'm doing it correct.
I have some profiles in my Kemper, everytime i change one of them, i store it, i think this is the procedure for saving them, i push store until the unit shows the message of profile stored. But the issue comes after i try to look at it and it doesn't appear, and the original profile never changes, i mean if i for example turn of delay and turn on reverb, after power down and up again the unit, the profile is there as i never changed.
I'm sure i'm doing something wrong here...but i thought that doing the store procedure will just the profile as i used....Any clue about this?
Thank you