Hey all!
So i've been losing my mind trying to figure this out - Basically all I want to do is use a Pro tools EQ to notch out problem frequencies from my amp/cab (The studio EQ on the kemper Q values are too wide and arn't really what I need) From what I understand I can run the chain like this
KPA DI SEND -> AMP -> MIC -> PREAMP/Interface with preamp ->DAW-> interface out -> KPA return in
But every time I do this when I go to profile I get a warning that there is no amp connected or signal too low . . . What am I doing wrong? and also how do I actually monitor what's going on during profiling ?
Im using pro tools with a Focusrite Saffire liquid 56
Any help would be immensely appreciated!