Question about kemper-interface-ipad chain

  • Hey I’m going to run stereo xlr out of the back of the kemper (non powered amp type) to the front of my steinburg ur242 interface & then to my iPad.. so kemper-interface-ipad.. to monitor using a mission Gemini powered amp in stereo do I then run lines out of the interface to the Gemini..

  • I think you're going to get latency with UR242 > iPad > amp > speakers. I would go with UR242 > amp > speakers and UR242 USB > iPad.

    I'm assuming the Gemini is a power amp for your monitor speakers?

  • Hey thanks for the reply.. my kemper is non powered and my mission Gemini is powered.. any advice taking this into consideration.. I was going to go kemper-ur242-ipad but then run the mission Gemini line out of the back of the ur242.. thanks again??

  • My setup is (Kemper non-powered):

    Kemper > UR244 > monitors (powered)

    UR244 > USB (Cuebase PC)


    This way I can play Kemper through monitors and PC through monitors at the same time.

    I would think the iPad would be the same setup except you may need the USB/Lightning convertor for the iPad. Not an iPad expert though, I just have one.