I would like to control the input volume like i would do with the volume knob of the guitar to clean up distorted profiles.
I often, after a solo, have to switch off effects, reduce the volume on guitar and start singing again.
A parameter to simulate the volume knob wold be helpful for this
but i want to keep the volume pedal on the output position.
Is there a parameter to control the input volume?
- wrbi
- Thread is marked as Resolved.
-
-
You can morph the gain in your rig. In System-Menue set "Rig-Button-Morph" and you can reduce the gain with the rig-button. Gain reacts in the same way as volume on guitar.
-
Thank you, i will try
-
I tried and it worked really good with higher gain profiles.
But today i had a nice clean sound, which was even nicer with reduced level on Guitar.
so it would still be nice to have such a parameter. -
If you keep using the volume knob on the guitar, it will eventually be easier than pushing the correct switch.
But, you could try this compromise:
1) keep your guitar turned down to rhythm volume.
2) program a single switch to turn on the solo effects and pure boost(in slot a b c or d). When you push the switch again, it will turn off the effects and reduce the guitar level. -
if you want to keep the Volume Pedal on the output but want to control the volume in front of the Stack so that it responds like a guitar volume you can use the Wah Volume in on of the Stomps. This is basically just the volume pedal but assigned to the Wah Pedal function so you can have Wah control Volume pre Stack in any rigs where you don’t actually use the wah effect.