For anyone who's using the Mission EP1 for both volume and wah...
My setup is working, I'm using a EP1 on pedal 5&6 on my KP-remote, seems to work fine basically.
Pedal works fine as a volume pedal, 0dB at heel, +5 at toe.
My Wah engages when I push down my EP1 (at toe position), pedal works fine as a wah.
However, this means that my wah engages just after my volume was set to +5dB... Quick fix is to put my wah effect on -5dB, but I'm looking for a better solution. When I push down my pedal again, wah disables again, and if I leave my pedal there, volume will still be +5dB.
Currently, I'll have to remember to go to heel position after turning of my wah, and even then this volume boostwill always be heard momentarily.
(Thus...looking for a way to put my volume back to 0dB officially (as is at heel) while way is enabled...)
Anyone else got the same problem?