Today when I played around with the Editor, I just realized that effects post the amp/cab does not work, but if I put the effects pre amp/cab it works. Have anyone experienced this?
Post effects not working.
- b_ryan
- Thread is marked as Resolved.
-
-
no. They are working fine on mine.
-
Today when I played around with the Editor, I just realized that effects post the amp/cab does not work, but if I put the effects pre amp/cab it works. Have anyone experienced this?
please check your output source settings for the output that you use for monitoring. Only Master Mono and Master Stereo will include the complete signal chain.
-
I use s/pdif in/out. But the output source page has the following:
Main Output: Master Stereo
Monitor Output: Off
Direct Output: Off
S/pdif Out: Git/stack
I tried to change it to git/Master mono and it works. Freakin’ amazing . But how does that effect my need of recording the dry and wet signal at the same time? Is it the same as git/stack? -
Obviously not the same since now you'll record any post effects instead of just the stack. But you'll still get the DI.
-
Isn’t the stack everything?
-
No. Loock at the front panel of the KPA and follow the visual path from left to right. That is also the signal chain. So Input is before the Stomps Section. The Stack is the amp/eq and cabinet which follows the stomps but is before the Effects. The effects then lead to the output. You can select the point in the chain where you want to take the output. The same is true of inserting a volume pedal. You can put i at several places in the signal path and achieve different results.
-
Damn....that makes totally sense. Thanx a lot to all involved
-
Does the stack option include any expression pedal controlling volume post stack?