Hey Mob, so here's my Question: since I did the update to the latest firmware, whenever I switch on individual effects on a rig within a performance, switch to another rig and then back again, the state of the effect doesn't revert back to it's saved on/off state, but rather stays like it was before switching rigs. I didn't change anything whatsoever other than doing the update. Is that intended? And most importantly: what do I need to do to get back to the old behavior?
I didn't experience this at last night's gig, changing Slots with The Remote.
Are you connected to Rig Manager when you experience this? If so, I think the Performance is in Edit Mode, and the FX status is retained when you change Slots within the Performance, in case you are intentionally updating it, before Storing the updated Performance.
Aaahhhh yes, that might very well be the case, i was indeed connected to RM when this happened. Will check tomorrow wether that's the reason. Thanks for the heads up! ??