Hi, Wondering if anyone has any ideas,
When using the Kemper DI to make profiles, they sounds off when the master volume on the amp is pushed.
When in Profile mode, the amp sounds good (am going Kemper into UAD Twin using Mikko IR to dial in the amp) - but when i profile the high end is off, sounds like there's a blanket over the amp profile. No amount of refining helps. When i profile using settings on the amp where the master volume is lower there is no major issue. This is with several amps (AFD100, Marshall SC20 and Marshall Vintage Modern)
If i use the amp into Boss Tube Amp Expander, out from that into the Kemper the profiles sound much closer so don't think its how its set up -
I use an XLS to TRS cable from Kemper DI into Kemper state as the Stage doesnt have an XLR input..
But i have also tried using XLR out of Kemper DI in Axe FX, Axe FX into Kemper stage with same results to try rule out the cable...