I will probably try this later this week when I setup to profile again, but when I profile an amp, is setting the EQ during profiling the same as tweaking after profile is saved? Will the amp retain the the changes as shown in the eq section, or will they all reset to 0 as the profile. If the EQ is not zeroed, then does profiling "flat" and tweaking after profiling sound the same as if you tweaked to the same numbers before?
Setting the EQ while profiling
- axeman61
- Thread is marked as Resolved.
-
-
As I recall, the last time I did this I'm fairly sure that tweaking the EQ during profiling was equivalent to tweaking the profile's EQ after the fact, except that the EQ is "baked in" to the profile's baseline and the EQ's in the profile will show up as flat until changed.
-
Thanx for the info. I did some more profiling yesterday and found that if you eq on the Kemper before profiling, once you store, the eq goes back to 0.