Kemper in the effects loop of an amp

    Is it possible to put the Kemper in the effects loop of an amp, just for the effects (delay, modulation, etc)? Can't seem to locate info on if this is possible or how to set up.


    Thanks!

    yes it’s possible. I can’t personally think of any reason to do it but it is possible.


    i can think of a few ways to do it but would strat with just connecting the FX send of the amp to the main input of the KPA. Connect the main output of the KPA to the FX return on the amp. Set output to Master Mono (unless you are feeding two separate amp FX Returns)


    now just turn off and lock the whole Stack block.


    if this gives problems with the FX send level being too strong. Try setting and FX Loop effect in Stomp A and use the direct input on the KPA to feed the FX effect.


    the final option would be much more convoluted and would involve plugging into the Kemper then using the FX Loop feature to send a clean guitar signal to the Amp input. From their sen the Amp FX send to the return of the KPA effects loop. Now turn off the Stack block in the KPA and send the main output to the FX return on the amp.