Can I in some way get a direct output using only the mod section?

    Hey everybody, does anyone know if you Can get a direct output using only the mod section, without the amp.

    I'm using the kemper stage, and I want to get a direct signal that uses the transpose, but when i select mod mono in the send 1 output i also get the amp and cab, and i dont want that.

    this is normal because the MOD section is located after the amp stack.

    You can use the transpose in the Rig Menu and place a mono FX loop before the amp stack to send the signal to the direct out.

    Adjust the Mix value in the mono loop so the signal get also send to the rest of the signal chain.