Low cut high cut output

  • i need an advise for the low and high cut in the output section, i m not familar with it.

    Please for explanation

    Dunlop Wah Q95 -> KPA -> main to FOH ->KRK6 -> Monitor out DXR10 -> EXP DVP3 -> Remote: Guitars: Slash Gibson Les Paul Custom Shop - James Tyler Variax JTV59 - Epiphone Les Paul with EMG 81 - Furch GN2 Nylon -> Maybach Lester 60

  • Low cut = High Pass filter

    High cut = Low pass filter


    This is referring to the high and low frequency content of the signal. As you move the crossover frequency point around (the only control in this case), you will hear all frequencies below/above being attenuated for the HPF/LPF respectively. Give it a try and you’ll hear what it’s doing right away.