Hi everyone,
I think there's a bug with the Low Cut and High Cut in the Editor but, I'm not sure if I'm the only one experiencing the problem.
I noticed that the values for the Low Cut amd High Cut parameters in the Output section are the same in the Editor. So the whole range of the Low Cut (up to 800/900 Hz) is before 1/4 of the way around the dial in the Editor. And if you go to the output section in the Kemper and then adjust the Low Cut from there and watch both screens, the values on the Editor are different and work differently than if you adjust from the Editor. And from the Editor it's pretty hard to find where the Low Cut is actually at. Not sure if that's how it's supposed to be but, it seemed like a bug or something to me.
Also, the High Cut parameter doesn't correspond between the Profiler and the Editor. For example : if you go in the output section on your Kemper and leave that screen up, and then turn the dial in the Editor, if you watch the screen of the Kemper, the values are totally different (like a big gap apart). And if you do it the other way around and adjust the High Cut on your Kemper and watch the Editor, the dial turns but values between the Editor and Kemper are different. So idk if the High Cut in the Editor isn't working properly or what the bug is.
Figured I'd ask about this and try to find out if it's a bug and if others are experiencing it. I hope I made sense and didn't sound too confusing or crazy lol!