Ambrosi ATM70 Amp for Kemper Toaster_SOLD

For Sale is an Ambrosi ATM 70 Amp for the Toaster, will work perfectly with the Kemper Kone or Kabinet

cause it gets 90 Watts @4 Ohm

Just Screw it to the Back of your unpowered Toaster and go

250 € inkl Shipping in Europe

Hi

this is mono, when you wire them correct you can drive 2 Kone with it in mono

This all i have

DATA SHEET

• Nominal Voltage: 230 / 115 V AC (on demand) / 50-60 Hz.
  
• Power chip: IC National LM3886, thermal convection cooling.
  
• Minimum / Maximum power absorption: 26 / 120 VA.
  
• Power Absorption in stand-by: 23 VA.
  
• Voltage Gain: 27 dB.
  
• Instantaneous Output Power: 135 W.
  
• Frequency Range: 27 Hz - 105 kHz +0.5 / -3.0 dB.
  
• Damping Factor: 200.
  
• Distortion Factor: THD+N: 0.1% 20-20,000 Hz.
  
• Signal-to-Noise Ratio: > 92 dB.
  
• Noise Voltage: 2.0 uV RMS, unweighted.
  
• Input Sensitivity @ 4 ohm: -0,6 dBV / 0.72 V.
  
• Solid-state Bridge Rectifier Stage.
  
• Dual power supply 34 V per branch with 2 x 2 AT, 250V, 5x20 mm fuses.
  
• 0.5 A T, 250V, 5x20 mm fuse.
  
• Protection Circuits: Over-Voltage, Under-Voltage, Short To Ground, Overloads, SPiKE Protection, Over-temperature.
  
• Mute / Active switch. Power switch.
  
• Main frame: 2-mm aluminium.

INPUT

1/4" unbalanced, 22 kohm.

Maximum Input Level: 2.0 Vpp @ 4 ohm. Settable through on-board trimmer.

OUTPUTS

• Monitor Out: 1/4" unbalanced for a line-level connection (external power amp, recording device, mixing desk and the like).
• Loudspeaker Outs: 2 x 1/4". Accept loudspeakers in the 4-16 ohm range (minimum load: 1 cabinet @ 4 ohm or 2 cabinets @ 8 ohm).

SIZE

360 x 117 x 88 mm (14,2" x 4,6" x 3,5").

Internal depth: 76 mm (3,0").

Weight: 2,0 kg (4,4 lbs).

paypal ok shipping ok

pm me for my PayPal adress