Input-Section-Noise-Gate as a Stomp

    I love the way the noise gate in the input section works.
    But i keep it locked to use it gobally if ther is some noise because of radiation or something else.
    ( at home i have it az zero, but at rehersal i have to turn it on a bit).

    So it would be great to chose it as a noise gate in the stomps section when using high gain sounds.

    Quote from Wheresthedug

    why not unlock it and save the settings as part of each rig?

    I have to change the settings of the input noise gate depending on the location.

    at home i don't need it. at rehersal i have to use it even for clean sounds.

    there are olnly some high gain sounds where i use a gate as Stomp and it would be nice to have one that behaves like the input gate.

    You could unlock it at home and use the settings stored by Rig.

    And - if needed - set it according to special gig environments and lock it during the gig.

    The only downside is, when you edit Rigs and store these during a gig and while Input Noise Gate is locked as you are capturing its level in the Rig.

    But then i have to bring it up to fit the high gain Sounds what will be far too much for the clean Sounds.

    I think your Solution is quite ok, but i would prefer the stomp.