Best way to connect the BAM 200

KenHPstudio · Oct 3rd 2020

Hey Guys,

Just picked up a BAM 200, want to connect to my unpowered kemper and my 2x12 mesa cab vintage 30's. What is the best way to connect to the Kemper? Also the BAM say 4 ohms for the speaker output my Cabinet is 8 ohms is this a problem? Regards Ken ..

Ruefus · Oct 5th 2020

I believe it says 4ohm minimum load. You'll be fine with an 8ohm cab. Class D amps (and lots of other solid state designs) can handle multiple impedance loads.

Roeffel · Oct 5th 2020

I rewired my 2x12 for 4 ohm to fully benefit the 200 W power. 8 ohm was ok too, but now it's insane loud

KenHPstudio · Oct 7th 2020

Thanks Guy's.. Did you connect the direct out or Monitor out of the Kemper to the input of the BAM? and did you change the db's as some have suggested?

Share