Kemper as effects board for a real amp without effects loop

joanesinu · Oct 10th 2020

Hello,

I have 65's JTM45 amp and I want to send the analog git + effects into the input. I can't find a way to do it.

If i select any rig, I disable amp and cabinet settings and connect the send to the amp input, the effects doesn't work. I think is due to the internal kemper structure where digital effect are into de digital amp loop, so when I disable the amp the effects go down too. This is my theory. Because in the output section I select Git+Processing for the send output and it doesn't send any effect.

Is posible to use the kemper with an amp like a effect board throwing everything to the imput?

Git Analog + effects

Greetins

Wheresthedug · Oct 11th 2020

I would set it up just like physical pedals - Guitar into front of Kemper then main out or monitor out to the input of the JTM.

kevinduren · Oct 11th 2020

I set up a performance to use with an amp. Basically, just had to turn off the amp and cabinet in the stack section and run monitor out to an amp. Works great.

joanesinu · Oct 20th 2020

I did as mentioned above.

Monitor out with cab and cabinet disabled into the main input. It works great.

I feel like my real pedals lost their purpose now...?

517138682526ce5895215d56f87e1ce93cc8da6e · Oct 22nd 2020

I'm wondering, isn't the signal that's entering the analog amp out of the KPA a lot hotter than what the amp is used to / made for? Could this cause any problems?

Wheresthedug · Oct 22nd 2020

You could just turn down the output to get a better level match.

Share