how do I save my output preset in RM3 editor

  • Hi,

    any idea how to save "output settings" in the rig manager editor.

    the Buttons says "Store Rig in Local Library" / "Store rig".

    But I don't wanna store the rig, just wan't to store my "out setting".


    Also I recognized that all factory output presets have a high cut activated at 830.6 Hz.

    This sounds very muddy.


    I am happy about any help.

    Be the force with you ;)

  • I'm not positive this is what you are looking for but in Rig Manager, I just dragged the output icon located at the end of the signal chain in the editor to a folder I created under All Presets > Local Library > Output Section


    It stored what I needed to change from one mode to another.

  • I'm not positive this is what you are looking for but in Rig Manager, I just dragged the output icon located at the end of the signal chain in the editor to a folder I created under All Presets > Local Library > Output Section


    It stored what I needed to change from one mode to another.

    With this I save the setting in the rig manager (local library).

    But I want to save it as a preset on the Kemper.

    So I would have to drag the output button on the left to All Presets -> MyKemper right?

    Be the force with you ;)

  • With this I save the setting in the rig manager (local library).

    But I want to save it as a preset on the Kemper.

    So I would have to drag the output button on the left to All Presets -> MyKemper right?

    I believe you just need to press and hold the output button until it blinks, then press store, then press OUTPUT section. This will make it available as a preset within the Kemper itself.