In performance mode, In one of the slots my pedalboard showed there was a morph there but when I engaged it, I couldn't find what it was operating and didn't want it to operate anything on that rig. (Plus I didn't set up a morph, it might have came in with a rig and I have the fx locked so it may not have functioned.) I've read about sweeping the dial to get rid of morphs but the button light stays on and makes you think there is something there when there's not. So I went into the menu where it has "clear module" but I didn't know what module was connected so I pressed "clear all" and (I believe)it cleared all the morphs 1-5 in that bank! Was that because I had that section locked and that is what will happen?
Right now for constancy I'm keeping both FX blocks locked. (easier than editing every rig with the same FX in performance mode) I understand by the manual clear all was just supposed to clear morphs in that rig but when locked it must clear the whole bank section that is locked? Can anyone confirm that? Disclaimer: there is a slight chance the others in that bank did not have morphs but I was pretty sure they did.