I‘m using the Kemper in a coverband. I‘d like to switch our lightsystem with the Kemper. It is possible to do this, because I take a new rig for every new song. The switching of the lightsystem is done by midi-programchanges, which are part of the settings of every slot.
Normally this works.
But partially the Kemper does not send the programchanges as I can see on a midi-watcher. The midi-clock-signal of the same slot is transferred - so there is a midi-signal, but not the programchange. The problem happens for all slots of the specific rig.
As I switch to another rig, there is no problem, everything works as programmed. Coming back to that specific rig shows the problem again.
I have already tested switching the midi-definition off in the slot and then again on. This did not help.
Does anyone have any suggestions to solve?
Thx in advance.