I recently purchased a Kemper Rack from eBay and after a few weeks of messing around I finally decided to update it. In the newest update folder there appears to be some presets that I am assuming are new effect pedals (Example would be the Klon preset files, Horizon..etc). How do I add these to the Kemper itself. I have only been using a USB stick and have not used Rig Manager at all yet. Can’t seem to find a tutorial on this. Thanks.
Effect Presets
- AndyBok
- Thread is marked as Resolved.
-
Hi, AndyBok,
Welcome, and congratulations on getting your Kemper Rack.
I would install and use Rig Manager (see link below) to install the Overdrive Presets (Klon etc.) to the Profiler.
Once you install Rig Manager, you should then be able to drag and drop the Overdrive Presets into the Profiler. I can't remember for sure - but Rig Manager may do that for you when you install it and connect it to the Kemper the first time.
Please check out the resources below.
Kemper Manuals and Quick Start guides
Rig Manager Download and Documentation
Cheers,
ST
-
Open the presets, then highlight them. Click and drag them over to the stick.
Be sure the stick is empty when you drag them over.
Plug it in to the Kemper and load.
-
Oops - I didn't know you can install the Presets using a USB stick.
I'd still install and use Rig Manager. There are lots of other reasons to use it.
ST
-
Hi, AndyBok,
I'm not familiar with using the USB stick for installing the Presets. However, you will need to be running Operating System 8.02 to use the Overdrive Presets you mentioned.
I'm assuming you have the files because you're looking at the Presets. Have you done the update to the Profiler?
-
do I drop these into shared in the stick?
Yes
