I opened the thread for the new OS 1.1.0v2 Public
This one addresses an issue where changing patches did result in audible clicks.
I am not able to upgrade until later tonight, so if someone has please share your feedback.
FW 1.1.0v2 Public Beta
- Stemast
- Closed
- Thread is marked as Resolved.
-
i've updated and seems to everything works great..
-
No issues with mine at this point.
-
No problem here either
-
All fine here, Houston!
-
looking good here too
-
Yeap, things are good here too
Rig changes are very quite with my set up, especially through s/pdif. I have also an overall impression of things being a bit quieter.
Good one!
-
Good! I was just about to report the problem myself. I was getting noise when switching rigs and sometimes when adjusting the gain.
-
I notice on the 'notes' it says...
"additional factory rigs for your enjoyment. In order to install the new
content, go to the SYSTEM menu and hit the soft button "Factory Rigs".
The new rigs will amend the existing portfolio, nothing will be deleted
or removed"So this just adds the new rigs and leaves everything else as is?
-
So this just adds the new rigs and leaves everything else as is?
Unless you've deleted/edited the factory rigs, in this case they are going to be restored, but they will not be duplicated if they are there
-
One small problem here.
I notice all the stomp LEDs remain 'On' even when I turn them 'Off'...the button light goes off, but the LED stays on...this can't be correct?
The only LED that switches off is the delay one.
-
One small problem here.
I notice all the stomp LEDs remain 'On' even when I turn them 'Off'...the button light goes off, but the LED stays on...this can't be correct?
The only LED that switches off is the delay one.
I believe it is normal and was always like this (going from memory here).
-
I believe it is normal and was always like this (going from memory here).
I think I agree. The leds were on for each effect that was used and the soft button was on/off respectively.
-
Have you guys noticed that G String's post for the FW 1.1.0v2 Public Beta release has been removed from the Announcements? And the version2 has been removed from the downloads section?
I believe they just dumped the previous (1.1.0 - 7448 ) version and relabelled the current (7459) as FW 1.1.0 in order to not create any confusion
-
I believe they just dumped the previous (1.1.0 - 7426) version and relabelled the current (7459) as FW 1.1.0 in order to not create any confusion
You are right, Chris.
They have added the comment for the clicks too. -
I believe it is normal and was always like this (going from memory here).
Correct, the led indicates that the slot is occupied by an fx
-
lol...my brain is fried.
I just put the Black front Panel onto my KPA, everything looks different & the LEDs glow more...thats why the stomp LEDs confused me.
-
lol...my brain is fried.
I just put the Black front Panel onto my KPA, everything looks different & the LEDs glow more...thats why the stomp LEDs confused me.
Yeah, right! Has Ken put you up to this to advertise the product??? -
Black front panel? Did you get it from Kemper or is it one of Crosshair's KPA skins?
